74
Model C606Operating Procedures
040803
Step 3
Return to the freezer with a small amount of
sanitizing solution. With a pail below the door spout,
dip the door spout brush into the sanitizing solution.
Brush clean the door spout, the bottom of the driven
spinner and spinner blade, and the syrup line
fittings. (See Figure 175.)
Figure 175
Note: To assure sanitary conditions are maintained,
brush clean each item for a total of 60 seconds,
repeatedly dipping the brush in sanitizing solution.
Step 4
With the syrup port brush, brush each syrup port
hole10to15times.Dipthebrushinsanitizing
solution before brushing each port.
(See Figure 176.)
Figure 176
Step 5
Fill the squeeze bottle with sanitizing solution. With a
pail beneath the door, insert the tube end of the
squeeze bottle into the syrup port, and squeeze the
bottle firmly. This action will force solution out of the
adjacent port and down around the spinner. This
procedure should be performed for at least 10
seconds per port. (See Figure 177.)
Figure 177
Step 6
Reinstall the syrup valve retainers.
Step 7
Install the restrictor cap on the freezer door spout.
(See Figure 178.)
Figure 178
To Next Page
Loading...
