22
Beater Door Assembly - Shake Side (See Figure 13)
ITEM
PART NO. DESCRIPTION QTY. FUNCTION WARR.
CLASS
1 032560 Seal-Drive Shaft 1 Provides seal from product inside
freezing cylinder to internal areas
of freezer.
000
2 050985 Shaft-Beater 7 Qt.
Fluted Blade
1 Connects beater assembly to gear
unit.
103
3 041103 Blade-Scraper-16” 2 Scrapes frozen product off wall of
freezing cylinder.
000
4 055605 Bearing -Door Front
1.390 OD
1 Allows beater assembly to turn
freely in hub of freezer door.
000
5 X50958 Beater A.-7 Qt. Fluted
Blade
1 Blends air and mix inside the
freezing cylinder and provides
force to dispense product.
103
6 033493 O-Ring 6” - Freezer
Door
1 Provides a seal between freezer
door and freezing cylinder.
000
7 X55825SER2 Door A.-Shake 1 Covers open end of freezing
cylinder and provides port for the
product to be dispensed.
103
8 055989 Nut-Stud 4 Tightening mechanism to secure
freezer door to freezing cylinder.
103
9 053890 O-Ring -Syrup Port
11mm ID x 2mm Green
4 Prevents leakage at syrup port
plug.
000
10 053867 Plug-Syrup Port 4 Seals off syrup ports in the freezer
door during the heat cycle.
000
11 054554 Retainer-Syrup Valve 4 Retainer pins which secure the
syrup valves in place.
000
12 020571 O-Ring - 1 -1/16 OD x
.139 W (Draw Valve)
2 Provides seal for draw valve in
freezer door cavity.
000
13 036053 Seal-Spinner Shaft 1 Provides a seal between draw
valve and spinner shaft.
000
14 034054 Spinner 1 Helps to blend mix with syrup in
freezer door cavity.
103
15 X59331 Blade A.-Spinner
Aluminum-HT
1 Blends mix with syrup in freezer
door cavity.
103
16 033107 Cap-Restrictor 1 Snaps over door spout so blended
product flows in a stream.
000
17 X57169 Valve A.-Draw 1 Seals off mix in freezer door
cavity. When raised, the port
opens, allowing product in
freezing cylinder to be dispensed.
103
Downloaded from www.dlmanuals.com
To Next Page
Loading...
