33
Heat Mode Symbol
When the HEAT MODE symbol
is
illuminated, the freezer is in the process of a
heat cycle. The heat mode symbol may be
selected to start a heat cycle following a
freezer soft lock condition.
For some international models, the heat
symbol can be selected to manually start a
heat cycle at any time.
Brush Clean Countdown - Displays the
number of days before the next brush cleaning
is required. When the display has counted
down to “1”, the machine must be
disassembled and brush cleaned within 24
hours.
Reset Mechanism
The reset button is located in the service
panel at the rear of the machine. (See
Figure 20.) It protects the beater motor from
an overload condition. Should an overload
occur, the reset mechanism will trip. To
properly reset the freezer place the power
switch in the OFF position. Press the reset
button firmly. Turn the power switch to the ON
position. Touch the WASH symbol
and
observe the freezer’s performance.
Figure 20
WARNING: Do not use metal objects
to press the reset button. Failure to comply
may result in severe personal injury or death.
If the beater motor is turning properly, touch
the WASH symbol
to cancel the cycle.
Touch the AUTO symbol
to resume normal
operation. If the freezer shuts down again,
contact your authorized service technician.
Air/Mix Pump Reset Mechanism
The reset button for the pump is located in the
service panel at the rear of the machine. (See
Figure 20.) The reset protects the pump from
an overload condition. Should an overload
occur, the reset mechanism will trip. To reset
the pump, press the reset button firmly.
WARNING: Do not use metal objects
to press the reset button. Failure to comply
may result in severe personal injury or death.
Adjustable Draw Handle
This unit features an adjustable draw handle
to provide the best portion control, giving a
better, consistent quality to your product and
controlling costs. The draw handle should be
adjustedtoprovideaflowrateof5to7-1/2oz.
(142 to 213 g.) of product by weight per 10
seconds. To INCREASE the flow rate, turn the
screw CLOCKWISE, and COUNTER-
CLOCKWISE to DECREASE the flow rate.
(See Figure 21.)
Figure 21
Downloaded from www.dlmanuals.com
To Next Page
Loading...
