52
4. Insert the b lack shielded brush into the
top side of the inlet valve. Scrub this area,
specifically around the steel ball.
(See Figure 77.)
Figure 77
5. Insert the b lack shielded brush into the
top side of the outlet valve. Scrub this
area, specifically around the steel ball.
(See Figure 78.)
Figure 78
6. Insert the black shielded brush, by the
non-bristle end, into the passageway
between the inlet valve and the outlet
valve. (See Figure 79.)
Figure 79
7. Move the brush back and forth to scrub
this passageway. Advance the brush
completely, and pull the brush out of the
valve body. (See Figure 80.)
Figure 80
8. Insert the b lack shielded brush into the
bottom side of the inlet valve. Move the
brush back and forth to scrub this area,
specifically around the steel ball.
(See Figure 81.)
Figure 81
9. Advance the brush completely through
the inlet valve, and pull the brush out of
the valve body.
10. Rinse all parts with clear water.
11. Sanitize the parts in McD Sanitizer
(HCS). Allow the parts to air dry after
sanitization.
Downloaded from www.dlmanuals.com
To Next Page
Loading...
