55
Draining Product From The Freezing
Cylinder
To drain the product from the freezing
cylinders on both sides of the machine, the
steps will be the same. Therefore, first drain
the product from the shake side, then go back
and duplicate these procedures for the soft
serve side.
1. Place the heater topping switches in the
OFF position by touching the heater
symbols
. The symbols will not be
illuminated when the heaters are off.
2. Cancel automatic operation by touching
the AUTO symbol
. (See Figure 89.)
Figure 89
3. Shake Side Only: Remove the shake cup
holder. Set it aside for cleaning later with
all parts.
4. Remove the hopper cover and agitator.
Take these parts to the sink to wash, rinse
and sanitize.
5. With a pail beneath the door spout, touch
the WASH and PUMP symbols
and
open the draw valve. (Shake Side:
Touch any flavor selection symbol to
open the draw valve.)
6. Drain the product from the freezing
cylinder and the mix hopper. (See
Figure 90.)
Figure 90
7. When the flow of product stops, touch the
WASH and PUMP symbols
,
cancelling the WASH and PUMP modes.
The shake draw valve will automatically
close when the WASH operation is
cancelled.
8. Remove the locking clip, mix feed tube,
pump clip and the assembled air/mix
pump. Place the parts into the parts tray.
9. Shake Side Only: Remove the syrup
lines from the freezer door by raising the
syrup valve retainers and pulling the
valves straight out of the door. Insert the
syrup hole plugs in the syrup ports. Lower
the retainer pins to secure the hole plugs
in the door.
Repeat steps 2 through 7 for the soft serve
side of the freezer.
Downloaded from www.dlmanuals.com
To Next Page
Loading...
