61
If the blades are in good condition, place
each scraper blade over the holding pins
on the beater assembly. (See Figure 104.)
Figure 104
Note: The holes in the scraper blade must fit
over the pins to prevent damage.
4. Holding the blades on the beater
assembly, insert the beater assembly in
the freezing cylinder. Engage the shaft
end firmly into the drive shaft socket.
(See Figure 105.)
11254
Figure 105
Note: When properly seated, the beater will
not protrude beyond the front of the freezing
cylinder.
5. Assemble the draw valve spinner
assembly. Inspect draw valve o-rings for
cuts or nicks. (Replace if cut or nicked.) If
draw valve o -rings are in good condition,
slide the 2 o-rings into the grooves of the
draw valve and lubricate.
(See Figure106.)
Figure 106
6. Lubricate the outer diameter of the
spinner shaft seal. Fill the cups on each
end of the seal with lubricant.
Figure 107
Downloaded from www.dlmanuals.com
To Next Page
Loading...
