62
7. Insert the spinner shaft seal into the
bottom of the draw valve as far as it will
go. The spinner shaft seal should fit into
the seal groove located inside the draw
valve cavity. (See Figure 108.)
11245
Figure 108
Important: Inspect to see that the
spinner shaft seal is correctly installed in
the groove. A worn, missing, or improperly
installed spinner shaft seal will cause
product leakage out the top of the draw
valve.
8. Lubricate the smaller end of the driven
spinner. (See Figure 109.)
Figure 109
9. Squeezing the split end together, insert
the driven spinner through the metal
opening of the draw valve until it snaps
into place. (See Figure 110.)
11246
Figure 110
10. Insert and align the draw valve spinner
assembly into the shake door as shown.
(See Figure 111.)
Figure 111
Downloaded from www.dlmanuals.com
To Next Page
Loading...
