63
11. Place the freezer door o-ring into the
groove on the back of the freezer door.
Lubricate the outside diameter of the front
bearing. Slide the front bearing into the
door hub.
Note: If necessary, put two small spots of
lubricant at the 10 o’clock and 2 o’clock
positions on the upper portion of the
freezer door o -ring to keep it in place.
Figure 112
12. Install the shake freezer door. Position the
freezer door on the four studs on the front
of the freezing cylinder. Align the top of
the draw valve with the valve lifter
bracket. Install the handscrews (short
handscrews at the bottom of the door).
Tighten equally in a criss-cross pattern to
insure the door is snug. Do not
over-tighten.
Figure 113
13. Lubricate the shaft of the spinner blade up
to the groove. (See Figure 114.)
Figure 114
14. Insert the spinner blade shaft into the
center of the driven spinner, and through
the draw valve cavity until the shaft
appears at the top of the draw valve. The
spinner blade must be aligned and
engaged to the driven spinner at the
bottom. This allows the spinner shaft to
raise high enough to be engaged into the
spinner coupling at the top.
(See Figure 115.)
Figure 115
Downloaded from www.dlmanuals.com
To Next Page
Loading...
