64
15. Raise the locking collar of the spinner
coupling and insert the spinner shaft into
the cavity of the coupling until the locking
collar can drop into the locked position.
(See Figure 116.)
Figure 116
16. Snap the restrictor cap over the end of the
door spout and install the syrup valve
retainer pins. (See Figure 117.)
Figure 117
Freezing Cylinder Assembly - Soft Serve
Side
Make sure the power switch is in the
OFF position. Failure to follow this instruction
may result in severe personal injury from
hazardous moving parts.
With the parts tray available for the soft serve
side:
1. Before installing the soft serve beater
drive shaft, lubricate the groove on the
beater drive shaft. Slide the beater drive
shaft boot seal over the small end of the
beater drive shaft and engage into the
groove on the shaft. Heavily lubricate the
inside portion of the boot seal and also
lubricate the flat end of the boot seal that
comes in contact with the rear shell
bearing. Apply an even coat of lubricant to
the shaft. DO NOT lubricate the hex end.
(See Figure 118.)
Figure 118
Note: When lubricating parts, use an
approved food grade lubricant (example:
Taylor Lube HP).
Downloaded from www.dlmanuals.com
To Next Page
Loading...
