92
Problem Shake Side
Probable Cause
Soft Serve Side
Probable Cause
Either Side
Probable Cause
Corrective Action
Product is
collecting on top
of the draw
Inadequate lubrication
of spinner shaft or
seal.
Lubricate properly.
valve.
Spinner shaft seal is
missing or worn.
Install or replace the spinner shaft seal.
Product is
collecting on top
of the freezer
door.
The top o-ring on draw
valve is improperly
lubricated or worn.
Lubricate properly or replace the o-ring.
Excessive mix
leakage from
the bottom of
door spout.
Bottomo-ringondraw
valve is improperly
lubricated or worn.
Lubricate properly or replace the o-ring.
Excessive mix
leakage into the
long drip pan.
The seal on drive shaft
is improperly lubricated
or worn.
Lubricate properly or replace the seal.
The seal is installed
inside-out on the drive
shaft.
Install correctly.
Inadequate lubrication
of the drive shaft.
Lubricate properly.
The drive shaft and
beater assembly work
forward.
Call an authorized service technician.
Worn rear shell
bearing.
Call an authorized service technician.
Gear box out of
alignment.
Call an authorized service technician.
Downloaded from www.dlmanuals.com
To Next Page
Loading...
