Taylor McDonald's C602 - Page 98

97
Problem Shake Side
Probable Cause
Soft Serve Side
Probable Cause
Either Side
Probable Cause
Corrective Action
Syrup continues
t
o
f
l
o
w
a
f
t
e
r
Air in syrup line. Follow syrup prime procedure.
t
o
f
l
o
w
a
f
t
e
r
drawing a shake.
Duckbill valve damaged.
Remove syrup nose fitting and clean. Replace duckbill valve.
Spinner shaft will not rotate to
b
l
d
i
d
Flexible coupling is broken.
Call an authorized service technician.
blend mix and syrup.
Pin is missing in quick disconnect of spinner coupling.
Call an authorized service technician.
Spinner motor is out on thermal overload.
Allo w the spinner motor to cool. Check lubrication on the spinner shaft.
Syrup toppings are not hot.
Topping heaters not ON
Select topping heater symbols. Symbols will be lit when heaters are ON.
No water is in topping well.
Fill to indicating mark.
The water is not hot enough.
Using a thermometer, check the water temperature in the topping well. It should be 140
_ F(60_C).
Downloaded from www.dlmanuals.com