ATP Operator Instructions
Turn the power switch off before starting to
clean the UTC tray.
Do not touch the components near the
UTC tray when cleaning the area below it.
Otherwise the electrical components of
the UTC tray could short circuit or cause
electric shock
.
You could hurt your self if you press it very
hard.
When you close the primary shutter base,
do not touch the area behind the push latch.
Relocation work of the unit should be
performed by authorized personnel.
You could get your fingers caught between
the push latch and the bracket on the
receiving side and hurt yourself
.
Improper relocation by user may result in
injury from the unit turning over.
To Next Page
Loading...
