ATP Operator Instructions
How to Clean the Primary Shutter
[Step 1]
Turn the power switch Off before starting cleaning.
[Step 2]
Open the front door and pull out the primary shutter base.
[Step 3]
Wipe away pill dust that has collected in the primary shutter.
[Step 4]
Open the primary shutter chute as shown below and wipe off pill dust collected in the moving parts of
the shutter chute.
[Step 5]
Replace the primary shutter to its original location and install the primary shutter base.
Note: The ATP must be cleaned before use and daily to ensure proper operation. If the unit is not cleaned,
packaging precision and product performance may decrease. It is the operator’s responsibility to keep the
ATP clean.
Note: Using excessive force during cleaning may damage the primary shutter.
To Next Page
Loading...
