ATP Operator Instructions
How to Replace the Packaging Paper (by Splicing)
A "Paper alarm" during packaging means that the unit has run out of paper and must be replenished.
When the "Paper alarm" occurs, it will package all pills in the pill path (2 packages) before stopping.
[Step 1]
Open the front door and use the packaging
mechanism handle to pull out the
packaging mechanism. (There is no need to
turn off the unit.)
[Step 2］
Remove used packaging paper from the
paper supply panel and remove paper from
the paper roll.
[Step 3］
As shown, place the removed paper on the
paper splicing board. Wrap the folded
paper around the paper splicing board to
secure it.
[Step 4]
Place the new paper roll on the paper
supply panel so that the open side of the
paper is facing the panel.
［Step 5］
As shown below, place the new paper on
the paper splicing board. Make sure
the old paper is spliced inside the new.
Packaging mechanism
handle
board
Secure the packaging paper
removed from the paper roll to
this frame.
Place the new paper on the outside of the old paper.
To Next Page
Loading...
