TCGRx ATP-E320W - Tablet Canister (Canister)

ATP Operator Instructions
|Part Names and Functions
19
Tablet Canister (Canister)
1. Sample medication and desiccant: Space for
inserting sample medication and desiccant.
Open the lid, remove the bottom cover, place
the sample medication in the space that is
visible from the front and place the desiccant in
the space behind the medication name card.
The sample shows a visual for canister refills.
The desiccant reduces the effect of humidity on
medication.
4. Separator: A part that allows the canister to
release medications one by one. The separator
uses a brush. The separator will become soiled
and deformed with long-term use. It is
recommended that you clean it regularly.
2. Medication name card: A card that indicates
the name and size of the medication. This card is
attached when the unit is shipped
.
5. Positioning groove:
This groove positions the
tablet canister when it is placed in the unit. It
ensures that the canister is correctly positioned.
3. Lid: The lid is hinged. Open this lid when
refilling medication. Be sure to close the lid.
Be sure to properly close the lid of the tablet
canister. If left open the lid may break when it
comes into contact with the unit.
6. Pins preventing incorrect placement Placing
a tablet canister in the wrong location could
lead to incorrect dispensing. Pins correspond to
holes in the motor base and prevent incorrect
canister placement.
NOTE: The separator in the tablet canister is a consumable. Consult TCGRx in the unlikely event of a malfunction.