ATP Operator Instructions
How to Clean the Main Hopper
[Step 1]
Be sure to turn the Power switch Off before you start
cleaning.
[Step 2]
Open the front door. The main hopper can be seen
between the packaging mechanism and primary shutter.
[Step 3]
The main hopper is normally locked. Pull the two latches
at the top of the main hopper(white resin knobs) to release the lock.
[Step 4]
Pull the main hopper towards you and remove it from the ATP. Take care not to drop it as it slides all
the way out. Remove the chute cover and wipe away any pill dust inside.
White resin knobs on the left and right
To Next Page
Loading...
