Teac AG-V2050 - Preset Tuning

Preset Tuning
The AG-V2050 has a preset memory. If the
frequencies of broadcasts are stored in this memory
which has a capacity of 30 stations (channels), they
can be tuned to by a simplified procedure.
@ Presetting
POWER ON
1. Tune to a station by either Auto, Manual or Direct
tuning.
2. Press the MEMORY button; the MEMORY indicator
will light in the display for approximately 5 seconds.
3. While the MEMORY indicator is lit, press the
numeric key(s) to input the channel number in
which the data (AM or FM band and frequency) for
the broadcast is to be stored.
Note: If a frequency has already been stored in a
specified channel, the old data will be lost
and replaced by the new data.
Ex.: Channel 1
Ex.: Channel 10
Ex.: Channel 20
Press twice, then Lo]
Ex.: Channel 30
Press three times.
Note: It is not necessary to press the "0" key to
input the unit's digit.
4. To release the memory function while the
MEMORY indicator appears in the display, press
the MEMORY button again.
@ Recalling Frequencies
Press the numeric key(s) corresponding to the channel
number to tune directly to a broadcast.
@ Using the Memory Scan function
When the MEMORY SCAN button (on the remote
control) is pressed, the preset channels in which
frequencies in the band (AM or FM) selected have
been stored are scanned at 5-second intervals. When
you hear a broadcast you want to listen to, release the
Memory Scan function by pressing the MEMORY
SCAN button again.
@ Using the Memory Skip function
Every time the MEMORY SKIP button (on the remote
control) is pressed, tuning skips to the next higher
channel broadcasting in the band selected.
= |