Teac AG-V2050 - AM Antenna

a
AM Antenna
@ AM Loop Antenna
A high-performance AM loop antenna is provided with
the receiver and this is sufficient for good reception in
most areas.
Attach the loop antenna to the snap-in hinge on the
supplied loop antenna stand then connect its wires to
the AM antenna terminals as shown. For details of
connecting antenna wires to the terminals, see "How
to connect antenna" on page 6.
Place the antenna stand on a shelf, etc. or attach it to
a wall, etc. with screws so that it is as far away as
possible from the entire system, speaker cords and
the power cord to prevent noise.
As shown, turn the loop antenna for the best
reception.
There is a hole in the loop antenna and this can be
used to suspend the antenna from a screw ina
window frame, etc.
U.S.A./Canada/General
Export Model
AM Loop Antenna
(provided)
Hole
Setting up AM Loop Antenna
On a shelf, etc. On a wall, etc.
Fix with screws.
YY
ns
Stand Del
Find the direction in which
reception is best.
Find the direction in which
reception is best.
@ AM Outdoor Antenna
If the AM loop antenna provided does not provide
sufficiently good reception (because you are too far
from the transmitter or in a concrete building, etc.), it
may be necessary to use an outdoor AM antenna.
Use an insulated wire more than 15 ft (5 m) long, strip
one end, and connect this to the terminal shown. The
antenna wire should be strung outdoors or indoors
near a window. For better reception, connect the
GND terminal to a reliable ground.
Note: Even when using an outdoor AM antenna, do
not disconnect the AM loop antenna.
AM Outdoor Antenna
U.S.A./Canada/General
Export Model
AM Loop Antenna
(provided)