TEC FS-1450 - Outline of Preparation Procedure before Operating the Ecr

- 7 -
EO1-11097
6. OUTLINE OF PREPARATION PROCEDURE BE-
FORE OPERATING THE ECR
This chapter shows the outline of set-up procedure of the ECR before actually starting the ECR
operation.
4
3
2
1
5
(1) (4) (5) (6) (8)(2) (3) (7)
WARNING!
Turn the POWER SWITCH to OFF before connecting the power cord.
Remove the cash register from the carton, referring to
Chapter "2. Unpacking". And take out all the parts and
accessories.
Remove the tapes and seals for holding parts or protecting
the register surfaces.
Plug the power cord of the register into a wall outlet. Make
sure that the outlet voltage matches that of the power
required for the register.
Insert the REG key into the Mode Lock.
Turn the Mode Lock to the REG position with the power ON.
REG
X
Z
SET
MGR
-
REG
X
Z
SET
MGR
-