- 10 -
EO1-11097
There are the following two ways of a journal paper feed procedure.
A: Manual installation
B: Installation using the [JF] key
A: Manual installation
1 Lift the green lever on the journal side.
2 Insert paper from the rear of the printer until
the leading edge of paper comes out by 30
cm.
3 Insert the leading edge of paper into the slit
of the take-up reel to take up paper two or
three times.
4 Place the take-up reel on the take-up holder.
5 Lower the green lever.
6 Attach the receipt cover.
B: Installation using the [JF] key
1 Insert paper from the rear of the printer until
it won't go no further.
2 Press the [JF] key to feed paper until the
leading edge of paper comes out by 30 cm.
3 Insert the leading edge of paper into the slit
of the take-up reel to take up paper two or
three times.
4 Place the take-up reel on the take-up holder.
5 Attach the receipt cover.
1
2
Installing the Journal Roll
Follow Steps 1 to 5 for "Installing the Receipt Roll" on the preceding pages, except that
the paper roll should be placed inner side holder of the two holders.
To Next Page
Loading...
