- 9 -
EO1-11097
5
6
There are the following two ways of receipt paper feed procedure.
A: Manual installation
B: Installation using the [RF] key
A: Manual installation
1 Lift the green lever on the receipt side.
2 Insert paper from the rear of the printer
until the leading edge of paper comes out
by 10 cm.
3 Lower the green lever.
4 Attach the receipt cover.
B: Installation using the [RF] key
1 Insert paper from the rear of the printer
until it won't go no further.
2 Press the [RF] key to feed paper until the
leading edge of paper comes out by 10
cm.
3 Attach the receipt cover.
Place the paper roll in the outer side holder of
the two roll holders.
To Next Page
Loading...
Need help?
General
