TEC FS-3600 - Split by Seat Number

Chapter 3 - Guest Check Functions Split a Check
FS-3600 Owner’s Manual 3-31
3.8.2 Split by Seat Number
To split checks into separate checks using {SEAT~NUMBER}
requires the option USE SEAT # in the System Config Table be set
YES.
Procedure
1. Recall the check.
• If seat numbers were not entered prior to sending the check
(i.e. all items are assigned to seat #1), items can be
reassigned using the {CHANGE~SEAT} key (see procedure
on page 3-16).
2. Press {SPLIT~BY~SEAT}.
3. Screen prompts: Enter number of checks
4. Index the number of new checks to create from this check and
press {ENTER}.
• A list of new check numbers display across the top of the
screen.
• Below the check buttons display a list of the seat numbers
entered on the check.
5. Touch a check button, and then touch each of the seats that
should be split to this check.
6. Continue until all seats have been assigned to the correct check.
7. Press {SPLIT}.
8. A list of the new check numbers display.
• To print one check, touch the button of the check and press
{PRINT}.
• To print all the new checks, press {PRINT}.
9. Press {DONE} to exit the split check screen.
10. End the service round by pressing {MEDIA}, {PRINT~CHECK}
or {TOTAL}.