Chapter 3 - Guest Check Functions Combine Checks
FS-3600 Owner’s Manual 3-39
3.10.5 Combine Stored Checks to One Table
This procedure is identical to using {ADD~TO~TABLE} except it
depends on ONE CHK/TBL in the System Setup/System Config.
Table (page 4 #2).
• YES will add items from both checks to the resulting check.
• NO will add a separate check to the table number.
ONE CHK/TBL set to NO
1. Enter items for a new check, or recall a stored check.
2. Index the table number of the check to which the current check
will be combined.
3. Press {TABLE~#}.
• The current check becomes a separate check for that table.
ONE CHK/TBL set to YES
1. Recall a stored check.
2. Index the table number of the check to which the current check
will be combined.
3. Prompt line displays message:
Change table?
4. Press YES.
5. Screen displays a message “Check still opened” then prompts:
Add Check?
6. Press YES.
• Items from the current check are added to the check number
entered. That check now displays on the screen.
7. End the service round by pressing {TOTAL}, {MEDIA} or
{PRINT~CHECK}.
To Next Page
Loading...
Need help?
General
