TechniSat DIGITRADIO UP 1 - Menu Operation

5.5 Retrieving displays
> Press the Info/Menu buon repeatedly to scroll through the information
available. You have the choice of viewing the following information:
In DAB+ mode (the selected function is identified with an “*”):
[Running text] (continuous text with additional information provided
by broadcasters etc.), [Signal intensity], [Channel type], [Ensemble],
[Frequency], [Signal quality], [Bit rate and Codec], [Time] and [Date].
In FM mode (the selected function is identified with an “*”):
[Radio text] (if transmied), [Channel type] (PTY), [Ps] (Programme Service
Name or Station Name or Frequency), [Audio Information], [Time] and [Date].
6 Menu operation
All the DIGITRADIO UP1 functions and seings are accessed via the menu. The menu
navigation takes place using the Info/Menu, <<, >> and Enter buons.
The menu is divided into submenus and, depending on the mode (DAB+ or FM),
contains dierent menu items or functions which can be enabled. To open the menu,
keep the Info/Menu buon depressed. To change to submenus, first of all press the
<< or >> buons to display a submenu, then press the Enter buon to retrieve the
submenu. An asterisk (*) highlights the current selection.
Close menu: press the Info/Menu buon repeatedly (depending on which
submenu you are in), or wait until the current radio channel is displayed again.
Seings are not saved until the Enter buon is pressed. If the Info/Menu is
pressed instead, the seings are not confirmed and saved (the Info/Menu
buon in this case acts as a “Back” buon).
The functions and buons to be pressed are shown in bold in this instruction
manual. Displays in [square brackets].
Some texts (e.g. menu items, station information) may be too long to show on
the display. Shortly thereaer, these will be shown as running text.
14