SPIN TRAINER: Service & Maintenance Manual - rev. 2.0
Page 9.1
9. CONFIGURING THE MACHINE
Carry out the procedure described in paragraph 7.1. “Disassembling the display” to access the dip-
switches on the CPU board. Dip-switch configuration 1 enables the printout function.
9.1. ENABLE PRINTING
On the SW release not TGS, it is possible to enable the printing using dip-switch #1:
Printing enabled
Printing disabled
9.2. UNIT OF MEASURE
Starting from release 2.2 TGS it is possible to set the unit of measure:
Weight in Kg and speed in Km/h
Weight in lbs and speed in mph
To Next Page
Loading...
