Technosoft 2019 7 iPOS360x VX-CAN/CAT Technical Reference
TechnoCAN (part no. P091.063.TechnoCAN.UM.xxxx) – presents TechnoCAN protocol – an extension of
the CANopen communication profile used for TML commands
IO-iPOS360X (part no. P091.028.IO-iPOS360X.UM.xxxx) – describes the IO iPOS360x I/O extension board
included in the iPOS360X Starter Kits.
If you Need Assistance …
If you want to … Contact Technosoft at …
Visit Technosoft online
World Wide Web: http://www.technosoftmotion.com/
Receive general information
or assistance (see Note)
Ask questions about product
operation or report suspected
problems (see Note)
Make suggestions about,
or report errors in documentation.
World Wide Web: http://www.technosoftmotion.com/
Email: contact@technosoftmotion.com
Fax: (41) 32 732 55 04
Email: hotline@technosoftmotion.com
Mail: Technosoft SA
Avenue des Alpes 20
CH-2000 Neuchatel, NE
Switzerland
1 Safety information
Read carefully the information presented in this chapter before carrying out the drive installation and setup! It
is imperative to implement the safety instructions listed hereunder.
This information is intended to protect you, the drive and the accompanying equipment during the product operation.
Incorrect handling of the drive can lead to personal injury or material damage.
The following safety symbols are used in this manual:
WARNING!
SIGNALS A DANGER TO THE OPERATOR WHICH MIGHT CAUSE BODILY
INJURY. MAY INCLUDE INSTRUCTIONS TO PREVENT THIS SITUATION
CAUTION!
SIGNALS A DANGER FOR THE DRIVE WHICH MIGHT DAMAGE THE PRODUCT
OR OTHER EQUIPMENT. MAY INCLUDE INSTRUCTIONS
SITUATION
CAUTION!
Indicates areas SENS
ITIVE TO electrostatic discharges (ESD) WHICH REQUIRE
HANDLING IN AN ESD PROTECTED ENVIRONMENT
1.1 Warnings
WARNING!
THE VOLTAGE USED IN THE DRIVE MIGHT CAUSE ELECTRICAL SHOCKS. DO
NOT TOUCH LIVE PARTS WHILE THE POWER SUPPLIES ARE ON
WARNING!
TO AVOID ELECTRIC ARCING AND HAZARDS, NE
DISCONNECT WIRES FROM THE DRIVE WHILE THE POWER SUPPLIES ARE ON
To Next Page
Loading...