Need help?Do you have a question about the Tecme NEUMOVENT and is the answer not in the manual?
Details the device's purpose, intended use, classification, and basic description.
Explains the operational definition, control circuit, variables, and breathing phases.
Covers Volume, Pressure, and Combined ventilation modes.
Lists essential inspections and tasks to be performed during maintenance.
Provides solutions for common problems encountered with the device.
Details how to inspect and verify sensor functionality and calibration.
Steps to check the functionality of air, oxygen, and expiratory flow sensors.
Procedures for inspecting the pneumotacograph and PEEP/inspiratory valves.
Provides step-by-step instructions for opening and disassembling the device.
Guidelines for safely disconnecting electrical cables from internal boards.
Procedures for removing shields and other internal parts.
Illustrations and parts lists for various device assemblies.
Diagrams and parts list for pressure regulators and nonreturn valves.
Diagrams and parts list for the pneumotacograph and proportional valves.
Lists components for the CPU, Ancillary, and Sensor boards.
Guides for performing initial calibration of the device and its components.
Steps for calibrating air flow, air valve, and oxygen valve.
Specific procedures for calibrating graph, air, and oxygen sensors.
Steps for initial setup, fittings check, alarm verification, and mode testing.
Procedures to test critical alarm functions like pressure and volume.
Guides for verifying the correct operation of various ventilation modes.
To Next Page
General