TECO E510s Series - Page 108

4-42
Group 12 Monitoring Parameters
Code Parameters Setting Range Default Unit
Control Mode
Attribute
V/F SLV
PM
SLV
(PID target value - PID feedback)
(100% corresponds to the maximum
frequency set by 01-02 or 01-16)
12-37
PID Output
Display output of the PID controller
(100% corresponds to the maximum
frequency set by 01-02 or 01-16)
% O O O *4
12-38
PID Setting
Display the target value of the PID
controller
(100% corresponds to the maximum
frequency set by 01-02 or 01-16)
% O O O *4
12-39
PID Feedback
Display the feedback value of the PID
controller
(100% corresponds to the maximum
frequency set by 01-02 or 01-16)
% O O O *4
12-41
Heatsink
Temperature*
Display the heatsink temperature of
IGBT temperature**
℃ O O O *4
12-43 Inverter Status
0000 0000
1: Inverter ready
1: During running
1: During zero speed
1: During speed agree
1: During fault detection (minor fault)
1: During fault detection (major fault)
Reser ved
O O O *4
12-74
Operation Pressure
Setting
0.01~25.50 2.00 PSI O X X
12-75
Pressure Feedback
Value
0.01~25.50 - PSI O X X
12-82 Motor Loading Display the loading current of motor - % O O O *4
12-83 Type of E510s
0：IP20 NFS(without functional safety)
1：IP20 FS(with functional safety)
2：IP66 NFS(without functional safety)
3：IP66 FS(with functional safety)
- - O O O *4