TECO E510s Series - Page 241

4-175
(2) Basic PID control(10-03=x0xxb)
This is the basic type of PID control. Refer to the figure 4.3.79.
Figure 4.3.79 Basic PID control
 PID Setup:
Enable PID control by parameter 10-03, PID target value (10-00) and PID feedback value (10-01).
(1) Select PID trget value：PID target value selection(10-00)
10-00=0：Keypad given
10-00=1：Analog AI1 given (default)
10-00=2：Analog AI2 given
10-00=3：Communication given
10-00=4：10-02 given
(2) Select PID feedback vale：PID feedback value selection(10-01)
10-01= 0：Keypad given
10-01= 1：Analog AI1 given
10-02= 2：Analog AI2 given
10-03= 3：Communication given
Figure 4.3.80 PID input selection