TECO E510s Series - Page 83

4-17
Group 00 Basic Parameters
Code Parameter Name Setting Range Default Unit
Control mode
Attribute
V/F SLV
PM
SLV
00-00
Control Mode Selection
0：V/F
2：SLV
5：PMSLV
0 - O O O *3
00-01
Motor’s Rotation
Direction
0：Forward
1：Reverse
0 - O O O *1
00-02
Main Run Command
Source Selection
0：Keypad
1：External Terminal (Control Circuit)
2：Communication Control (RS-485)
3：PLC
1 - O O O
00-03
Alternative Run Command
Selection
0：Keypad
1：External Terminal (Control Circuit)
2：Communication Control (RS-485)
3：PLC
0 - O O O
00-04
Operation Modes For
External Terminals
0：Forward/Stop-Reverse/Stop
1：Run/Stop- Reverse/Forward
2：3 Wire Control Mode Run/Stop
0 - O O O
00-05
Main Frequency
Command
Source Selection
0：UP/DOWM of Keypad
1：Potentiometer on Keypad
2：External AI1 Analog Signal Input
3：External AI2 Analog Signal Input
4：External Up/Down Frequency
5：Communication Setting Frequency
6：Reserved
7：Pulse Input(*6)
2 - O O O
00-06
Alternative Frequency
Command Source
Selection
0：UP/DOWM of Keypad
1：Potentiometer on Keypad
2：External AI1 Analog Signal Input
3：External AI2 Analog Signal Input
4：External Up/Down Frequency
5：Communication Setting Frequency
6：Reserved
7：Pulse Input(*6)
0 - O O O
00-07
Main and Alternative
Frequency Command
Modes
0：Main or Alternative Frequency
1：Main Frequency+ Alternative
Frequency
0 - O O O
00-08
Communication
Frequency Command
0.00~599.00
0.00 Hz O O O *4
00-09
Frequency Command
Save on Power Down
0：Disable
1：Enable
0 - O O O