TECO JSDG2S-100A3-E - Page 248

5-123
Hn613.0/Hn613.1~Hn616.0/Hn616.1 DO-1~ DO-4 Pin Function
Hn619.0/Hn619.1~Hn622.0/Hn622.1
DO-5~ DO-8 Pin Function
Initial Value Unit Setting Range Effective RS-485 Address
Change with Mode -- 00 ~ 20 Power Re-set
Each parameter is
different
Setting Description:
Sett
ing
Description
Code Contact Operation Function
00 NON Not Used
01 RDY Servo Ready
02 ALM Servo Error
03 ZS Zero Speed Signal
04 BI Mechanical Brake Signal
05 INS Speed Reached Signal
06 INP Positioning Completion Signal
07 HOME
Return to Origin Completion
Signal
08 INT Torque Reached Signal
09 P1
Tool Magazine Mode Selection
Tool Position Display 1
0A P2
Tool Magazine Mode Selection
Tool Position Display 2
0B P3
Tool Magazine Mode Selection
Tool Position Display 3
0C P4
Tool Magazine Mode Selection
Tool Position Display 4
0D P5
Tool Magazine Mode Selection
Tool Position Display 5
0E P6
Tool Magazine Mode Selection
Tool Position Display 6
0F OV Motor Overload Signal
Setti
ng
Description
Code Contact Operation Function
10 BAT
Encoder Battery Abnormality
Signal
11 LIT Left and Right Limit Signal
12 VDO Virtual contact digital output
13
E-SY
N
E-cam synchronization complete
signal output
15 LM During Torque speed limit
16 PC During P control
17 SOFF Servo Soff signal
18 KCF Turret calibration completed
19
ABSH
OME
ABS encoder origin return
complete signal
1A
E-CL
AM
E-cam workpiece clamping
signal output
1B
E-STO
POUT
E-cam pause signal output
1C ENC Encoder abnormal signal
1D SLIT
Software left and right limit
signal
1E - Reserved
1F BI2
The second mechanical brake
signal
20 INP_T Tool magazine output 2