5-161
EC911 E-Cam cutting length
Initial Value Unit Setting Range Effective RS-485 Address
100 0.1mm 1 ~ 50000
Effective after Confirmed
080BH
Setting Description: The total length of a single item to be cut.Set the cutting length of the item; this
size must match the diameters of main/auxiliary axle. If the setting value is small,
then the diameters of main/auxiliary axle should not be too long to avoid AL023
resulted from incorrect cutting curve planning.
EC912 Distance between E-Cam start material and the cutting point
Initial Value Unit Setting Range Effective RS-485 Address
100 0.1mm 1 ~ 50000
Effective after Confirmed
080CH
Setting Description: The definition is the distance between cutting material start position and cutter
start position. If the cutting material is put on the cutting point directly, then set
to 0.
EC914 E-Cam rotary cut synchronous time
Initial Value Unit Setting Range Effective RS-485 Address
10 ms 1 ~ 65535
Effective after Confirmed
080EH
Setting Description: Set the required time of synchronization. Please remember this parameter can
only generate correct synchronization time when ECA18 is correctly set.
EC915 E-Cam rotary cut DO delay time
Initial Value Unit Setting Range Effective RS-485 Address
0 200us 0 ~ 10000
Effective after Confirmed
080FH
Setting Description: When entering the synchronization zone, the auxiliary driver will output DO
signal. If the user wishes to avoid the cutting at speed turning point, then this
parameter can be set to delay the synchronization signal.
Cutting material start position
EC912
Cutter path
Cutter start position
Feeding direction
Feeding axle
Cutting axle
To Next Page
Loading...
