5-160
Parameter Description Parameter Description
Pn349
Full-closed loop rotation direction
selection
EC914 Synchronization zone time
EC901 Set as 2 EC915 Synchronization zone DO delay time
EC902.0 Physical/Virtual axle selection EC916 Auxiliary axle screw pitch
EC902.2 If to use return to origin EC917
Maximum proceed distance of auxiliary
axle
EC903 Cutting quantity selection EC918 Main axle average proceeding speed
EC907 Main axle encoder resolution EC920 Maximum return speed of rotary cut
EC908 Auxiliary axle encoder resolution EC921
Acceleration/deceleration time of rotary
cut
EC909 Main axle EC922 Enable parameter change write-in
EC911 Cutting length EC923 Parameter fine-tune factor
EC912
Distance between start material and
cutting point
EC924.0 Rotary cut return origin return function
EC913 S-curve time
EC907 Encoder resolution of E-Cam main axle
Initial Value Unit Setting Range Effective RS-485 Address
2500 ppr 1 ~ 32768
Effective after Confirmed
0807H
Setting Description: Main axle (feeding axle) encoder resolution.
EC908 Encoder resolution of E-Cam Auxiliary axle
Initial Value Unit Setting Range Effective RS-485 Address
2500 ppr 1 ~ 32768
Effective after Confirmed
0808H
Setting Description: Auxiliary axle (cutter axle) encoder resolution.
EC909 E-Cam feeding diameter
Initial Value Unit Setting Range Effective RS-485 Address
100 0.1mm 1 ~ 10000
Effective after Confirmed
0809H
Setting Description: Main axle (feeding axle) diameter
EC916 E-Cam auxiliary screw pitch
Initial Value Unit Setting Range Effective RS-485 Address
100 0.1mm 0~ 50000
Effective after Confirmed
0810H
Setting Description: E-Cam auxiliary axle screw pitch
The main axle refers to the conveyor diameter and the auxiliary axle to the cutting axle diameter. If it
is hard to measure precisely, the user can rotate motor by one cycle and acquire the main axle
diameter by dividing the moved distance of the conveyor by Pi. The same method can be used to
verify the screw pitch of auxiliary axle.
To Next Page
Loading...
