TECO JSDG2S-100A3-E - Page 371

7-9
Parameter Code Name and Function Unit RS485 Index
Deceleration Smoothing Constant (TSL)
-- Pn323
Internal Position Command S-type Acceleration /
Deceleration Constant (TACC)
0.4ms 031EH -
-- Pn324 CNC Tool Magazine Quantity Setting - 031FH -
-- Pn325 CNC Tool Tray Return to Zero Position pulse 0320H/0321H -
-- Pn326 CNC Tool Tray Reduction Ratio - 0322H -
-- Pn327 Tool Change Rotational Speed 1 rpm 0323H -
★
Pn329 Pulse Command Smoothing Filter 2ms 0325H 231DH
-- Pn330 Pulse Command Moving Filter 0.4ms 0326H 231EH
-- Pn331 Turret Magazine Backlash Compensation Parameters pulse 0327H/0328H -
-- Pn332.0
Internal/External Position Command Acceleration /
Deceleration Method
- 0329H -
-- Pn332.3
-- Pn333
Internal Position Command S-type Deceleration
Constant (TDEC)
0.4ms 032AH -
-- Pn334 PTRG Trigger Delay Time Parameter 4ms 032BH -
-- Pn335 Tool Change Rotational Speed 2 rpm 032CH -
-- Pn336.0
Automatic Low Frequency Vibration Suppression
Enablement Selection
- 032DH 2324H
-- Pn337 Automatic Low Frequency Vibration Suppression 1ms 032EH 2325H
-- Pn338 Low Frequency Swinging Detection Level 0.1% 032FH 2326H
-- Pn339
First Set Low Frequency Vibration Suppression
Frequency
0.1Hz 0330H 2327H
-- Pn340
First Set Low Frequency Vibration Suppression
Parameter
- 0331H 2328H
-- Pn341
Second Set Low Frequency Vibration Suppression
Frequency
0.1Hz 0332H 2329H
-- Pn342
Second Set Low Frequency Vibration Suppression
Parameter
- 0333H 232AH
-- Pn343
Third Set Low Frequency Vibration Suppression
Frequency
0.1Hz 0334H 232BH
-- Pn344
Third Set Low Frequency Vibration Suppression
Parameter
- 0335H 232CH
★
Pn346.0 Full-closed loop function activation
- 0337H 232EH
★
Pn346.1 Full-closed loop origin signal source selection
★
Pn346.2 Full-closed loop function dividing selection
★
Pn346.3 Full-closed loop function speed feedback selection
-- Pn347 Maximum of full-closed loop error pulse 0338H/0339H 232FH
★
Pn348 Full-closed loop encoder resolution ppr 033AH/033BH 2330H
★
Pn349 Full-closed loop direction - 033CH 2331H
★
Pn350.0 Enable gantry synchronization function
- 033DH -
★
Pn350.1
Gantry synchronization D triggered to enable
asynchronous function