TECO JSDG2S-100A3-E - Page 692

10-6
Servo Driver Model
JSDG2-□□□□-E
JSDG2S-□□□□(-L)
JSDG2S-□□□□-E(L)
200V class / 400V class
Input / Output Signal
Position Output
Output
Type
Phase A, B, Z differential Output / Phase Z Open Collector Output
Division
Ratio
Pulse output: 1 ~ pulse number of one encoder revolution
÷
4
(Internal parameter random value setting)
Digital input
[NPN/PNP]
12 points
can be
planned
arbitrarily
Servo start, abnormal alarm clear, P/PI switching, CCW/CW direction drive
prohibition, external torque limit, pulse error removal, servo lock,
emergency stop, internal speed command selection, control mode switching,
position command prohibition, gain switching, electronic gear ratio
numerator selection, internal position command trigger, internal position
command pause, start to return to origin, external reference origin, internal
position command selection, virtual contact digit input, etc.
Digital output
[NPN/PNP]
8 points
can be
planned
arbitrarily
Servo ready, servo abnormal, zero speed signal, mechanical brake signal,
speed arrival signal, positioning completion signal, origin return completion
signal, torque arrival output completion signal, magazine mode tool position
display, motor overload signal, encoder battery abnormal signal, positive
and negative limit signals, virtual contact digital output, torque limit, P
operation, etc.
Analog monitor
output
(JSDG2S-E(L)
does not have
this function)
2 points
can be
planned
arbitrarily
Speed command, speed feedback detection, torque command, torque
feedback, pulse input command, position offset, electrical angle, primary
circuit (Vdc Bus) voltage, etc.
Environment
Location
Indoors (avoid direct sunlight)
Non-corrosive Mist (avoid fumes, flammable gases and dust)
Altitude Up to 1000M
Temperature Operating Temperature: 0 ~ 50ºC; Storage Temperature: -20 ~ +85ºC
Humidity Up to 95%RH (non-condensing)
Vibration
10 ~ 57Hz
：
20m/s
2
；
57 ~ 150Hz
：
2G
Safety
Certification
CE Declaration In compliance with EN61800-3 (CE&RE) and EN61800-5-1 (LVD)
UKCA
Declaration
In compliance with BS EN61800-3 (CE&RE) and BS EN61800-5-1 (LVD)
UL
Certification
UL508C