5-128
Hn623 Digital output contact control method selection
Initial
Value
Unit Setting Range Effective
RS-485
Address
H0000 -- H0000 ~ H00FF (hexadecimal)
Effective after
Confirm Ke
0517H
Setting description: Determines the output status of the DO contact through bit setting; the bit setting
adopts the conversion from binary to hexadecimal. First, correspond
DO-01~DO-08 to bit 1~8 of the binary system, convert the planned binary
system to hexadecimal, and then perform settings.
Binary bit representation: 0: The function setting determines whether DO is
ON or OFF
1: The com munication setting determines
whether DO is ON or OFF
When the parameter setting is H0000, it means that all DO contacts are controlled by
function settings; setting it as H00FF means that all DO contacts are controlled by Hn624.
For example: To set DO contacts DO-1, DO-3, DO-6 to be controlled by communication
and the rest to be controlled by function settings, the digital input contact corresponding
to the binary bit is: [0010 0101], in which setting the first bit as 1 means that DO-1 is
controlled by communication, setting the second bit as 0 means DO-2 is selected by
function and so on for the other bits. After converting to hexadecimal, it can be set as: [H
0 0 2 5]
Hn624 Communication controlled digital input contact status
Initial
Value
Unit Setting Range Effective
RS-485
Address
H0000 -- H0000~H00FF (hexadecimal)
Effective after
Confirm Ke
0518H
Setting description: Bit setting is used to determine the contact status when communication control is
used for communication controlled DO contact; refer to the descriptions of
Hn623 for the bit setting method.
Binary bit representation: 0: DO contact OFF
1: DO contact ON
Note) The use of this function must be in accordance with the setting of
parameter Hn623.
To Next Page
Loading...
