TECO JSDG2S-20A-EL - 7-3-4 Speed Control Parameters (Sn2□□)

7-63
7-3-4 Speed Control Parameters (Sn2□□)
Sn201 Internal Speed Command 1

【
5-3-1
】
Initial Value Unit Setting Range Effective Cn029 Reset
100 rpm
-1.5*Rated Rotational Speed ~
1.5*Rated Rotational Speed
-- --
RS-485 CANopen EtherCAT Pi Pe Pt S T
0201H 2201H 2201H - - - O -
Setting Description: In Speed Control, the DigitalInput Contact SPD1, SPD2 can be used to switch 3 sets of Internal
Speed Limit. When using Internal Speed Limit 1, the DigitalInput Contact SPD1, SPD2 states are as
the following combination:
Digital Input Contact SPD2 Digital Input Contact SPD1
0 1
Sn202 Internal Speed Command 2

【
5-3-1
】
Initial Value Unit Setting Range Effective Cn029 Reset
200 rpm
-1.5*Rated Rotational Speed ~
1.5*Rated Rotational Speed
-- --
RS-485 CANopen EtherCAT Pi Pe Pt S T
0202H - - - - - O -
Setting Description: In Speed Control, the DigitalInput Contact SPD1, SPD2 can be used to switch 3 sets of Internal
Speed Limit. When using Internal Speed Limit 2, the DigitalInput Contact SPD1, SPD2 states are as
the following combination:
Digital Input Contact SPD2 Digital Input Contact SPD1
1 0
Sn203 Internal Speed Command 3

【
5-3-1
】
Initial Value Unit Setting Range Effective Cn029 Reset
300 rpm
-1.5*Rated Rotational Speed ~
1.5*Rated Rotational Speed
-- --
RS-485 CANopen EtherCAT Pi Pe Pt S T
0203H - - - - - O -
Setting Description: In Speed Control, the DigitalInput Contact SPD1, SPD2 can be used to switch 3 sets of Internal
Speed Limit. When using Internal Speed Limit 3, the DigitalInput Contact SPD1, SPD2 states are as
the following combination:
Digital Input Contact SPD2 Digital Input Contact SPD1
1 1