5-156
Parameter Description Parameter Description
EC901 Set as 1 EC907 Main axle encoder resolution
EC902.0 Physical/Virtual axle selection EC908 Auxiliary axle encoder resolution
EC902.2 If to use return to origin EC909 Main axle
EC903 Cutting quantity selection EC910 Auxiliary axle diameter
EC904 Cutter quantity selection EC911 Cutting length
EC905 Synchronous angle selection EC912
Distance between start material and
cutting point
EC906 Start angle selection EC913 S-curve time
Pn349
Full-closed loop rotation direction
selection
EC904 E-Cam cutter quantity selection
Initial Value Unit Setting Range Effective RS-485 Address
1 -- 1 ~ 4 Effective after Confirmed 0804H
Setting Description: Tool number per rotation,tool number means the cutter number installed on
auxiliary axle machine and the position of each cutter must divide 360-degree
equally. For example: when there are three cutters, then the separation between
each cutter must be 120-degree.
EC905 E-Cam synchronous angle
Initial Value Unit Setting Range Effective RS-485 Address
30 degree 1 ~ 120
Effective after Confirmed
0805H
Setting Description: When the flying shear function is selected, the synchronized angle refers to the
angle the auxiliary axle travels when the main axle and auxiliary axle shares the
same speed (Definition: 1 revolution = 360-degree).This parameter determines
the angle used by cutting synchronization and it will divide the cutting point in
the range of 180-degree. For example: when the setting is 60-degree, the
synchronization zone is between 150-degree and 210-degree.
150 degree210 degree
0 degree point
180 degree point
To Next Page
Loading...
