5-158
EC909 E-Cam feeding diameter
Initial Value Unit Setting Range Effective RS-485 Address
100 0.1mm 1 ~ 10000
Effective after Confirmed
0809H
Setting Description: Main axle (feeding axle) diameter
EC910 E-Cam cutter diameter
Initial Value Unit Setting Range Effective
RS-485Address
100 0.1mm 1 ~ 10000 Effective after Confirmed 080AH
Setting Description: Auxiliary axle (cutter axle) diameter
The main axle refers to the conveyor diameter and the auxiliary axle to the cutting axle diameter.
If it is hard to measure precisely, the user can rotate motor by one cycle and acquire the main axle
diameter by dividing the moved distance of the conveyor by Pi.
EC911 E-Cam cutting length
Initial Value Unit Setting Range Effective RS-485 Address
100 0.1mm 1 ~ 50000
Effective after Confirmed
080BH
Setting Description: The total length of a single item to be cut.Set the cutting length of the item; this
size must match the diameters of main/auxiliary axle. If the setting value is small,
then the diameters of main/auxiliary axle should not be too long to avoid AL023
resulted from incorrect cutting curve planning.
EC912 Distance between E-Cam Sensor to cutter point
Initial Value Unit Setting Range Effective RS-485 Address
100 0.1mm 1 ~ 50000
Effective after Confirmed
080CH
Setting Description: To measure the distance from cutting material sensor to the cutting point. The
definition is the distance between the start positions of cutting material and
cutting point. If the material is put on the cutting point directly, then set to 0.
180-degree=cutting point cutting point
Main axle feeding axle
Cutting material
To Next Page
Loading...
