TECO JSDG2S-20A-EL - Page 367

7-5
Parameter Code Name and Function Unit RS485 Index
Valu e
-- Cn057
Second Stage CW Direction Torque Command Limit
Valu e
% 003CH 2039H
-- Cn058
Delay Time of Switch Stage 1 Torque Limit to Stage 2
Torque Limit
4ms 003DH 203AH
-- Cn059.0 AutoTuning Enabling Selection - 003EH 203BH
-- Cn060
OFFLine-tuning Operation Command Number of
Revolutions Setting
0.1rev 003FH 203CH
-- Cn061 OFFLine-tuning Operation Maximum Speed rpm 0040H 203DH
-- Cn063.0
Automatic Mechanical Vibration Suppression
Enablement Selection
- 0042H 203FH
-- Cn064 Mechanical Vibration Detection Level - 0043H 2040H
-- Cn065 First Set Notch Filter Depth - 0044H 2041H
-- Cn066 Second Set Notch Filter Frequency Hz 0045H 2042H
-- Cn067 Second Set Notch Filter Quality Factor - 0046H 2043H
-- Cn068 Second Set Notch Filter Depth - 0047H 2044H
-- Cn069 Third Set Notch Filter Frequency Hz 0048H 2045H
-- Cn070 Third Set Notch Filter Quality Factor - 0049H 2046H
-- Cn071 Third Set Notch Filter Depth - 004AH 2047H
-- Cn072 Fourth Set Notch Filter Frequency Hz 004BH 2048H
-- Cn073 Fourth Set Notch Filter Quality Factor - 004CH 2049H
-- Cn074 Fourth Set Notch Filter Depth - 004DH 204AH
-- Cn075 Fifth Set Notch Filter Frequency Hz 004EH 204BH
-- Cn076 Fifth Set Notch Filter Quality Factor - 004FH 204CH
-- Cn077 Fifth Set Notch Filter Depth - 0050H 204DH
-- Cn084.3
Automatically detect communication type encoder
model selection
- 0057H 2054H
-- Cn085
Magnetic pole angle position automatically detects the
alignment duty
% 0058H 2055H
-- Cn086 Analog voltage over-temperature protection function 0.01V 0059H 2056H
-- Cn087 EMC stop speed linear deceleration constant ms 005AH 2057H
-- Cn089 Regenerative Resistor Resistance Setting
0.1
ohm
005CH 2059H
★
●
Cn090.3
No detection of linear motor encoder Z phase
disconnection function
- 005DH 205AH
-- Cn097.0 Motor disconnection protection flag
- 0064H 2061H
-- Cn097.1 EMC stop function selection
★
Cn097.2 Pulse encoder signal input phase sequence
-- Cn097.3 Linear motor pitch detection
-- Cn098 Motor cable disconnection detection time ms 0065H 2062H
-- Cn099 Overload limit value % 0066H 2063H