Tecsun S-2200x - Setting up Your S-2200 X; Setting the Clock (24-Hour Format); Setting the FM Frequency Range; Setting the MW Tuning Step and am (MW;LW;SW) Frequency Range

8
Getting Started - Setting up your S-2200x
ENABLING/DISABLING LONGWAVE (LW)
With the device off, press and hold the [ 2 ] (LW ON/OFF) button, the display shows “ ” (enabled) or “ ”
(disabled). To select the LW frequency band, power on the device and then quick press the [ MW/LW ] button
to select the LW frequency band (press twice if necessary).
SETTING THE FM FREQUENCY RANGE
S to use the radioet the frequency range to correspond with the country in which .
1) Turn the device off.
2) the (FM SET) button, and then turn the main tuning knob . The Press and hold [ 1 ] display will show
- - -“ ”, “ ”, “ ” or “ ” to indicate the corresponding range: 64 108MHz, 76 108MHz, 87 108MHz
- . Instead of rotating the knob to select the FM range, you can also press [ 1 ] repeatedly.or 87.5 108MHz
3) Quick the FM rangepress [ ] to confirm , or wait for 2 seconds for the system to auto confirm.
Display indicates “ ”:
● tuning to .MW steps are set 9 kHz
● - Asia, MW frequency range is 522 1620 kHz (for Europe, Africa, Oceania).
LW frequency range is 50 - 522 kHz● .
SW frequency range is 1621 - 29999 kHz ● .
SETTING THE MW TUNING STEP AND AM (MW/LW/SW) FREQUENCY RANGE
the (9/10kHz) button With the device off, press and hold [ 3 ] to set the tuning step and frequency range of
MW that corresponds with the country in which the radio. to use
Display indicates “ ”:
MW tuning steps are set to 10 kHz.●
MW frequency range is 520 - 1710 kHz (for North and South America).●
LW frequency range is 100 - 519 kHz.●
SW frequency range is 1711 - 29999 kHz. ●
SETTING THE CLOCK (24-HOUR FORMAT)
1) Press and hold the [ TIME ] button until the hours indicator starts flashing.
2) Use the numeric keys to enter the current time (hours + minutes is four digits). Alternatively, rotate the
[ TUNING ] knob to adjust the hours, then quick press [ TIME ] to confirm. Then adjust the minutes,
followed by a quick press of the [ TIME ] button to confirm the setting.
Tip: With the device on, quick press [ TIME ] to display the current time. Quick press [ TIME ] again to return
to the radio frequency display.