Tecsun S-2200x - Display Options; Display Backlight; Activate; Deactivate BEEP Sound; Keylock

29
DISPLAY OPTIONS
● With the device off, quick press the [ DISPLAY/SNOOZE ] button
repeatedly to view the alarm time of “Timer A” and “Timer B”.
With the device on, quick press the [ DISPLAY/SNOOZE ] button ●
repeatedly to view the signal strength/signal-to-noise ratio, the memory
location (preset) of the current frequency (in VM mode only, but not
in AP), the alarm time of Timer A and Timer B, and the current clock time.
With the device on, quick press the [ TIME ] button , the display will show the current time. Quick press ●
again to return to frequency display.
DISPLAY BACKLIGHT
With the device on, press and hold the [ ] (DISPLAY/SNOOZE) button to set your preference:
“ ”: Backlight is set to always-on. When turning the device off, the backlight turns off as well. When
pressing a button or rotating a tuning knob the backlight turns back on and is set to always-on.
“ ”: Backlight turns on when a button or tuning knob is operated and turns off after 5 seconds.
ACTIVATE / DEACTIVATE “BEEP” SOUND
With the device off, press and hold the [ BEEP ON/OFF ] ( ) button to activate
or deactivate the confirmation beep sound:
“ ” : Beep sound is heard when using the keypad to enter a frequency, alarm or
clock time and for (most) function buttons.
“ ” : Beep sound is turned off.
KEYLOCK
To activate the keylock, press and hold the [ STEP FAST-SLOW ] (LOCK) button .
The lock “ ” icon is displayed and the buttons and tuning knobs are disabled.
Press and hold the button again to unlock.