23
Recalling AP Time-Specfic MW (AM) and SW Memories
1) Press and hold the [ PAGE ] (AP) button to enter the AP mode.
2) Select the MW (AM) or SW frequency band.
3) Rotate the main tuning knob to select a stored frequency. Alternatively, press and hold the [ VF/VM ] (SCAN)
button to perform a memory scan. The device scans all stored frequencies of the selected band in the
current time-specific memory, staying on each frequency for 5 seconds before continuing to the next
one. To stop the scan and listen to a memory, quick press any button except [ DEL. ] and [ M ] .
Tips:
If “ ” is displayed after entering MW or SW in AP mode, it means that there are no previously stored ●
frequencies in the current time period (see for an overview). Press and hold the Table 2 on page 14
frequency band button to auto tune and store frequencies in the current AP time period, or quick press the
[ VF/VM ] (SCAN) button to exit AP mode.
While in AP mode, it is possible to recall FM and LW frequencies that are stored in memory pages 01-24. ●
To Next Page
Loading...
