AFG31000 Series Arbitrary Function Generator Service Manual
13
Operating requirements
Use the following information to safely install your instrument.
To operate your instrument:
1. Place the instrument on a cart or bench, observing clearance requirements of 50 mm (2 in.) from
the sides and rear.
2. Before operating, make sure that the ambient temperature is between 0 °C to +50 °C (+32 °F to
+122 °F).
CAUTION. To make sure that the instrument has the appropriate cooling, keep both sides of the
instrument clear of obstructions.
Check and protect connectors
The source voltage and frequency should be between 100 V to 240 V and 47 Hz to 63 Hz.
The instrument will also support 115V, 360-440Hz.
WARNING. To reduce the risk of fire and shock that may cause personal injury or death, make sure
that the mains supply voltage fluctuations do not exceed 10% of the operating voltage range.
To check input and output connectors:
1. Locate the output connectors on the front panel.
2. Locate the input connectors on the front panel.
NOTE: When connecting a cable, make sure to distinguish the input connector from the output
connectors to avoid making the wrong connection.
Operating basics
To Next Page
Loading...
Need help?
General
