Analyzing Wavef
orms
14. Select the polarity you want to test.
15. Toggle Pass/Fail Test On to start the
mask test.
16. Toggle Repeat On to run the mask test
continuously.
17. Click the Pass/Fail Results tab to view
the test r esults.
18. Click Pass/Fail Test On to start the mask
test.
19. Click Reset to reset the totals and clear
any violations.
Quick Tip
s
If the signal is not within the m ask, enable Autoset to center the waveform in the mask.
DPO7000 S eries Quick Start User Manual 67
To Next Page
Loading...
