Analyzing Wavef
orms
11. Click the Tolerance tab, and then set the
tolerance.
Tolerance sett
ings greater than 0% make
the mask test harder to pass, settings
less than 0% make the test easier to
pass.
Use 0% if you want the mask as
specified in the standard. Changing the
percentage al
lowsyoutodomargin
testing.
12. Select the Pass/Fail Setup tab, and then
set up the pass/fail parameters. (When
acquisitio
n mode is Waveform Database,
the # of Wfms label becomes Samples.)
13. Select your Pass/Fail Test Notifications.
66 DPO7000 Series Q uick Start User Manual
To Next Page
Loading...
