Command Groups
Command
Description
TRIGger:CLKRec:CRC:PHASEERRP2P?
Returns the ph
ase error peak-to-peak
measurement from the connected Clock
Recovery instrument
TRIGger:CLKRec:CRC:PHASEERRRMS? Returns the phase error RMS measurement
from the conn
ected C lock Re cov e ry
instrument
TRIGger:CLKRec:CRC:RCONfigdevice Restores the connected Clock Recovery
instrument to the settings from one of the
non-volati
le setup locations in the Clock
Recovery instrument
TRIGger:CLKRec:CRC:RELock Causes the connected Clock Recovery
instrument to search for the data rate
TRIGger:CLKRec:CRC:RESETLockcount
Resets the lock count to zero on the
connected Clock Recovery instrument
TRIGger:CLKRec:CRC:SCONfigdevice Saves the current settings of the connected
Clock Re
covery instrument to one of the
non-volatile setup locations in the Clock
Recovery instrument
TRIGger:CLKRec:CRC:SERIalnum? Returns the serial number of the connected
Clock R
ecovery Instrument
TRIGg
er:CLKRec:CRC:STANdard
Sets o
r queries the communications standard
of the connected Clock Recovery instrument
TRIGger:CLKRec:CRC:STANDARDList? Returns a comma-separated list of the
standards available on the connected Clock
Reco
very instrument
TRIG
ger:CLKRec:CRC:SUBCLOCKAmpl
Sets
or queries the sub-rate clock output
amplitude of the connected Clock Recovery
instrument
TRIGger:CLKRec:CRC:SUBCLOCKDiv Sets or queries the division ratio of the
sub
-rate clock of the connected C lock
Recovery instrument
TRIGger:CLKRec:CRC:
SUBCLOCKDIVList?
Returns a comma-separated list of available
sub-rate clock divisors of the connected
C
lock Reco very instrument
T
RIGger:CLKRec:CRC:SUBCLOCKOutput
S
ets or queries the state of the sub-rate clock
output of the connected Clock Recovery
instrument
TRIGger:CLKRec:CRC:SWRev? Returns the firmware revision string of the
connected Clock Recovery instrument
TRIGger:AUTOSync
Autosyncs to the currently selected
waveform, those pattern sync settings that
have their AutoSync options set
TRIGger:AUTOSync:DATARate Sets or returns the AutoSync option for data
rate selection (on or off)
DSA/CSA/TDS8X00/B Series Programmer Manual 2-39
To Next Page
Loading...
Need help?
General
