• Runt T
rigger menu
• Logic Trigger menu
• Setup & Hold Trigger menu
• Rise/Fall Time Trigger menu
• Video Trigger menu
• Bus Trigger menu
• Sequence Trigger menu
Bus Trigger configuration
Use the Bus trigger menus to trigger on bus-related events (Start, Stop, Missing Ack, Address, Data, and so on).
Note: Y
ou must add a bus to the Waveform view before you can trigger on it. Add a math, reference, or bus
waveform on page 71.
To open the Bus trigger menu:
1. Double-tap the T
rigger badge on the Settings bar.
2. Set the Trigger Type to Bus.
3. Select the bus on which to trigger in the Source field.
Use the following links to access trigger settings for specific buses.
ARINC429 serial bus trigger settings panel on page 200
Audio serial bus trigger settings panel on page 201
CAN serial bus trigger settings panel on page 202
FlexRay serial bus trigger settings panel on page 204
I2C serial bus trigger settings panel on page 206
LIN serial bus trigger settings panel on page 207
MIL-STD-1553 serial bus trigger settings panel on page 209
Parallel serial bus trigger settings panel on page 211
RS-232 serial bus trigger settings panel on page 211
SPI serial bus trigger settings panel on page 212
USB serial bus trigger settings panel on page 213
Trigger types
Use the following links to see more information on specific trigger types.
• Edge Trigger menu
• Pulse Width Trigger menu
• Timeout Trigger menu
• Runt Trigger menu
• Logic Trigger menu
• Setup & Hold Trigger menu
• Rise/Fall Time Trigger menu
• Video Trigger menu
• Bus Trigger menu
• Sequence Trigger menu
Menus and dialog boxes
3 Series Mixed Domain Oscilloscope Printable Help 199
To Next Page
Loading...
