Connecting probes
Probes and cables connect the oscilloscope to your device under test (DUT). Use a probe that best matches your signal measurement
needs.
Figure 2: Connecting probes to the instrument
1. T
ektronix Versatile Probe Interface (TekVPI)
These probes support two-way communication with the oscilloscope through on-screen menus and remotely through programmable
support. The remote control is useful in applications like ATE where you want the system to set probe parameters.
2. Tektronix Versatile Probe Interface (TekVPI) for Passive Probes
Install your instrument
3 Series Mixed Domain Oscilloscope Printable Help 36
To Next Page
Loading...
