Tektronix TDS210 - Page 110

Command Descriptions
2-90
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
DATa:SOUrce REFB
Specifies that reference waveform REFB will be transferred in the
next CURVe? query.
DATa:SOUrce?
Might return REFA, indicating the source for the waveform data that
is transferred using the CURVe? command.
CURVe?, WFMPre?, WAVFrm?
DATa:STARt
Sets or queries the starting data point for waveform data transfers.
This command lets you transfer partial waveforms to and from the
oscilloscope.
Waveform
DATa:STARt <NR1>
DATa:STARt?
<NR1> is an integer value tha t ranges from 1 to 2500, and speci fies
the first data point that will be transferred. Data is transferred from
<NR1> to DATa: STOP or 2500, whic hever is less. When
DATa:STOP is less than DATa:STARt, the values are swapped
internally for CURVe?.
DATa:STARt 10
Specifies that the waveform tra nsfer will begi n with data point 10.
DATa:STARt?
Examples
Related Commands
Group
Syntax
Arguments
Examples